31
1
Re-registering an edit point
Locate the new edit point by performing the jog or
shuttle operation, and press the IN (or OUT) button
and SET button at the same time to re-register the
edit point.
2
Modifying an edit point in 1-frame increments
(trimming function)
Press the TRIM button while holding down the IN
(or OUT) button.
Each time the
i
button is pressed, the point is
moved ahead by one frame.
Conversely, each time the
j
button is pressed, the
point is moved back by one frame.
3
Resetting edit points
1
Resetting both an edit IN point and OUT
point
Press (TC CLR = RESET) on the <HOME>
menu.
(This takes effect only in the CTL mode.)
2
Resetting either an edit IN point or OUT point
Press the button among the number keys
while holding down the IN (or OUT) button.
<Notes>
• An edit OUT point can be reset even while
editing is in progress.
• In the eject mode, the IN and OUT points are
automatically reset.
C
F4
Modifying edit points
Automatic Editing (deck-to-deck)
1
Press the IN (or OUT) button to check the edit
point.
The value of the registered edit point appears on
the display.
2
While holding down the IN (or OUT) button, press
the PREROLL button to check the picture at the
edit point.
The tape is cued up to the edit IN (or OUT) point,
and a still picture of the point appears.
• If “STOP” has been selected as the setup menu
item No.307 (AFTER CUE-UP) setting, the VTR
is set to the E-E mode provided that EE has
been selected as the <HOME> menu
(OUTPUT) setting.
F1
3
By holding down the IN and OUT buttons at the
same time, check the editing duration. The
duration appears on the display.
How the duration is calculated
• When two edit points have been set
The duration between the two points is
calculated.
• When only one edit point has been set
The duration between the data which has been
set and the current address is calculated.
• When no edit points have been set
The duration of the previously edited section is
calculated.
Checking the edit points
