89
Chapter 5 Preparation
Mounting and Adjusting the Lens
Mounting the Lens
1
Raise the lens clamping lever and remove the
mount cap.
Mount Cap
Lens Clamping Lever
2
To mount the lens, align the indentation at the
top center of the lens mount with the center
mark of the lens.
Mark
3
Lower the lens lever to firmly tighten the lens.
4
Secure the cable through the cable clamp, and
plug it into the LENS connector.
LENS Connector
Cable
clamp
For details on the current provided by the lens
terminal, refer to page 165.
5
Adjust the lens flange back.
For details, refer to [Adjusting the Lens Flange
Back] (page 90).
NOTE
• Please refer to the lens instruction manual for
guidance on lens handling.
• When the lens is removed, install the mount cap to
protect the device.
