Error signals
Additional information
EN-33
Error signals
* This light goes off when the connection is complete.
Indicator
Indicator
status
Printer status Solution Page(s)
POWER On Power ON
–
18
Off Power OFF
ACCESS On* Connected to a
digital camera, or
the printer is
cooling off
Wait for a while. Do not disconnect
the digital camera or PC.
–
Blinking
slowly
Communicating
Blinking
very slowly
Printing
––
PAPER Blinking
slowly
Out of paper Replace the paper-in tray. 22, 32
RIBBON Blinking
slowly
End of ink
ribbon
Replace the ribbon cartridge with a
new one.
19, 32
No ribbon
cartridge is set
Set a ribbon cartridge into the printer. 19
The paper and
the ribbon
cartridge are
incompatible
Use a ribbon cartridge for 100 × 148
mm (4 × 6) printing when printing on
100 × 148 mm (4 × 6) papers, and use
a ribbon cartridge for 89 × 127 mm
(3.5" × 5") printing when printing on
89 × 127 mm (3.5" × 5") papers.
21
ACCESS and
PAPER
Blinking
together
Paper jam Remove jammed paper. 36
ACCESS and
RIBBON
Blinking
together
Communication
error
Check whether the digital camera
supports PictBridge.
–
Turn the printer off and on, then try
printing again. If the error persists,
contact an authorized Olympus
service center.
–
ACCESS, RIBBON,
and PAPER
Blinking
together
Internal problem Contact an authorized Olympus
service center.
–
Doya_E.book Page 33 Thursday, November 11, 2004 10:50 AM
