EN 19
En
How to attach the camera table to the digital camera
In order to load the camera into the Case, attach the camera table (located on the front-lid side of the
Case) to the digital camera.
Using the electronic flash
To attach the combination of the FL-20 Electronic Flash and the PFL-01 underwater flash case or the
FL-36 Electronic Flash and the PFL-E01 underwater flash case to this Case, connect the hot shoe cable
provided with the PFL-01 or PFL-E01 to the camera and to the hot shoe cable connector on the front lid
side of this Case as described below. Note that the camera’s built-in flash cannot be used when an
external electronic flash and case are installed. Be sure to set the automatic pop-up setting of the camera
to OFF so that the builtin flash will not pop up automatically.
1 Attach the camera table to the tripod seat section on
the bottom of the digital camera. Use the camera’s
tripod screw hole for attaching.
2 The camera table has fixed up-down and front-rear
orientations. To ensure that it is properly attached,
refer to the illustration on the right.
1 Before loading the camera in the Case, connect the
hot shoe cable’s connector to the Case’s hot shoe
cable connector.
Up
Down
Front
Rear
PT-E03_EN.Book Page 19 Tuesday, March 20, 2007 7:21 PM
