Installation
^
Make the worktop cut-out as shown
in "Building-in dimensions".
Remember to maintain the minimum
safety distances (see "Safety
instructions for installation").
^
Seal the cut surfaces on
wood/laminated worktops with a
suitable heat-resistant sealant to
avoid swelling caused by moisture.
Make sure that the sealant does not
come into contact with the top of the
worktop.
^ Feed the connection cable down
through the cut-out.
^ Place the hob in the cut-out without
securing it.
If the corners of the frame are not
flush with the worktop surface, the
corner radius (ß R4) can be carefully
scribed to fit.
^
Connect the hob to the mains (see
"Electrical connection").
^
Connect the appliance to the gas
supply (see "Gas connection").
^
Secure the appliance at the back and
front using the fixings supplied. See
"Securing the appliance".
KM 2356
37
