^
Pull the arm of the soft-close
mechanism c outwards to holder r.
^ Place hinge pin d into the soft-close
mechanism from above.
^
Remove red retaining clip b.
^
Refit cover a.
^
Position the appliance in its final
location.
^
Make sure that you unscrew the
adjusting foot under the lower hinge
until it sits on the floor. Then unscrew
the foot by a further 90°.
Aligning the side of the appliance
door
If the appliance door is not in line with
the side walls of the appliance, it can
be aligned by adjusting the upper
bearing block.
^
Remove cover m from the inside of
the bearing block and slide it out.
Changing the door hinging
62
