All fitting instructions given are for a
right hand hinged appliance. If you
have converted the appliance to left
hand hinging you will need to adapt
these instructions accordingly.
Building into a peninsular run
When built into a peninsular run, the
rear of the building-in niche must be
fitted with a kitchen furniture panel.
Aligning the housing unit
The housing unit must be carefully
aligned using a spirit level before
installing the appliance. The unit
corners must be at right angles, as
otherwise the furniture door will not
align correctly with the 4 corners of the
appliance.
Preparing the appliance
^ Slide cover strip a (with the bumps
facing downwards) into the holder,
and secure by fitting the bumps into
the keyhole slots.
^ Push the appliance three-quarters of
the way into its housing unit.
When doing this, make sure that the
mains cable does not get trapped.
^
With 16 mm thick unit walls:
Shorten sealing strip b to the height
of the niche.
Stick the sealing strip to the side of
the appliance on which the door is
opened.
Clip spacer piece c over the hinges.
Building in the appliance
39
