RS-232C
30
13. Red ADC gain Adjustment (Color R)
(Command2:w)
➜ Adjust the Red gain of ADC part.(RGB)
Transmission
Data Min : 0 ~ Max : 64
*
Refer to ‘Real data mapping 1’.
Data Min : 0 ~ Max : 64
[ j ] [w] [ ] [Set ID] [ ] [Data] [Cr]
[w] [ ] [Set ID] [ ] [OK] [Data] [x]
Ack
14. Green ADC gain Adjustment (Color G)
(Command2:y)
➜ Adjust the Green gain of ADC part.(RGB)
T
ransmission
Data Min : 0 ~ Max : 64
*
Refer to ‘Real data mapping 1’.
Data Min : 0 ~ Max : 64
[ j ] [y] [ ] [Set ID] [ ] [Data] [Cr]
[y] [ ] [Set ID] [ ] [OK] [Data] [x]
Ack
15. Blue ADC gain Adjustment (Color B)
(Command2:z)
➜ Adjust the Blue gain of ADC part.(RGB)
T
ransmission
Data Min : 0 ~ Max : 64
*
Refer to ‘Real data mapping 1’.
Data Min : 0 ~ Max : 64
[ j ] [z] [ ] [Set ID] [ ] [Data] [Cr]
[z] [ ] [Set ID] [ ] [OK] [Data] [x]
Ack
16. Low Power
(Command2:q)
➜ To reduce the power consumption of the projector.
T
ransmission
Data 0 : Low Power Off
1 : Low Power On
Data 0 : Low Power Off
1 : Low Power On
[ j ] [q] [ ] [Set ID] [ ] [Data] [Cr]
[q] [ ] [Set ID] [ ] [OK] [Data] [x]
Ack
17. Auto Configure
(Command2:u)
➜ To adjust picture position and minimize image shaking
automatically. It works only in RGB mode.
T
ransmission
Data 1 : To set
Data 1 : To set
[ j ] [u] [ ] [Set ID] [ ] [Data] [Cr]
[u] [ ] [Set ID] [ ] [OK] [Data] [x]
Ack
18. Input Select
(Command2:b)
➜ To select input source for the Set.
T
ransmission
Data 20 : Video 30 : S-Video 40 : Component
50 : RGB-DTV 60 : RGB-PC 70 : DVI-DTV
80 : DVI-PC
Data 20 : Video 30 : S-Video 40 : Component
60 : RGB-PC 80 : DVI-PC
[x] [b] [ ] [Set ID] [ ] [Data] [Cr]
[b] [ ] [Set ID] [ ] [OK] [Data] [x]
Ack
External control device setup
*The transmission data for RGB-DTV(Data:50) input select is
changed to RGB-PC(Data:60) for the identical mode processing.
In like manner, the data of transmission for DVI-DTV(Data:70)
input select is changed to DVI-PC(Data:80).Therefore,if you
send command to select RGB-DTV or DVI-DTV source, you will
recieve changed data in the Ack message.
