8-162
Default Setting (System Menu)
POP3 Security
Select the communication protocol according to the type of security employed by the POP3 server. The default setting
is Off.
NOTE: POP3 (E-mail RX) must be set to On in Protocol Detail on page 8-151.
The table below shows the available settings.
* You can change the port number using Command Center RX.
Use the procedure below to make the setting.
1 In the Sys. Menu/Count. menu, press the or key to
select [System/Network], and press the OK key.
A login screen will appear. Then, enter the user ID and
password with administrator privileges to log in, and
press [Login] (the Right Select key).
2 The System/Network menu appears.
3 Press the or key to select [Network Setting].
4 Press the OK key. The Network Setting menu appears.
Item Description
Off Do not use security employed by the POP3 server.
SSL/TLS Encryption is applied any data communication. To enable POP3 security, the
POP3 port may have to be changed according to the server settings.
Typically, 995* for SSL/TLS is well-known POP3 port.
STARTTLS Encryption is applied any data communication. Typically, 110* for STARTTLS
is well-known POP3 port.
Sys. Menu/Count.:
a
b
1
Report
2
Counter
*********************
[ Exit ]
3
System/Network
Login User Name:
L
b
*******************
Login Password:
[ Login ]
System/Network:
a
b
*********************
2
I/F Block Set.
3
Security Level
[ Exit ]
1
Network Setting
Network Setting:
a
b
*********************
6
Host Name
7
LAN Interface
[ Exit ]
5
Secure Protocol
