FCC/IC Notice
This devicecomplies with part 15 of the FCC rules.
Operation issubject tothe following twoconditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
To comply with FCC radiation exposure
requirements, use of this device for body-worn
operational configurations is limited to accessories
tested and approved by Kyocera Wireless Corp.
Other accessories used with this device for body-
worn operations must not contain any metallic
components and must provide at least22.75mm
separation distance including the antenna and the
user’s body.
This model phone meets the government’s
requirements for exposure to radio waves.
Yourwireless phone is a radio transmitter and
receiver. It is designed and manufactured not to
exceed the emission limits for exposure to
radiofrequency (RF) energy set by the Federal
Communications Commission of the U.S.
Government. These limits are part of
comprehensive guidelines and establish permitted
levels of RF energy for the general population. The
guidelines are based on standards that were
developed by independent scientific organizations
through periodic and thorough evaluation of
scientific studies. The standards include a
substantial safety margin designed to assure the
safety of all persons, regardless of age and health.
The exposure standard for wireless mobile phones
employs a unit of measurement known as the
Specific Absorption Rate, or SAR. The SAR limit set
by theFCC is1.6W/kg.* Tests forSAR are conducted
using standard operating positions specified by the
FCC with the phone transmitting at its highest
certified power level in all tested frequency bands.
Although the SAR is determined at the highest
certified power level, the actual SAR level of the
phone while operating can be well below the
maximum value. Thisis because the phone is
designedto operateatmultiplepowerlevelsso asto
useonly thepowerrequired toreachthenetwork. In
general, thecloser you areto awireless basestation
antenna, the lower the power output.
Before a phone model is availablefor sale to the
public, itmustbe tested and certifiedto theFCC that
it does not exceed the limit established by the
government-adopted requirement for safe
exposure. The tests are performed in positions and
locations (e.g., at the ear and worn on the body) as
required by the FCC for each model. The highest
SAR value for thismodel phone when tested for use
at the ear is 1.53 and when worn on the body, as
described in this userguide, is 0.74. (Body-worn
measurements differ among phone models,
depending upon available accessories and FCC
requirements). SAR value shownis worstcase value
for a QCP 2035. A typical SAR value for QCP 2035
when tested foruse atthe earis 1.13 W/kg andwhen
worn on the body, as described in this user guide, is
0.505 W/kg. (Body-worn measurements differ
among phone models, depending upon available
accessories and FCC requirement). The highestSAR
value when tested for use at the ear is 1.5 W/kg and
when worn on the body, as described in this user
guide, is 1.48 W/kg. This is the worst case value.
While there may be differences between the SAR
levels of various phones and at various positions,
they all meet the government requirement for safe
exposure. The FCC has granted an Equipment
Authorization for thismodel phone with all reported
SAR levels evaluated asin compliance with the FCC
RF emission guidelines. SAR information on this
model phone is on file with the FCC and can be
found under the Display Grant section http://
www.fcc.gov/oet/fccid after searching on FCC ID
OVFQCP 2035. Additional informationon SAR can
be found on the Cellular Telecommunications
Industry Association (CTIA) web-site at http://
www.wow-com.com.
