To extend the frequency range to the 12 GHz range (high band) or for
reception from more than two satellites, additional control signals are
required for LNB actuation and signal selection.
The DiSEqC™ signal is responsible for this. This is a special
modulation of the existing 22 kHz signal.
The requirement is that you have not made any changes in the
The DiSEqC™ signal is used to switch between the target satellites.
keys to select the satellites for which you want
to change the DiSEqC™ setting and confi rm your selection with
If you want to add a new satellite,
the procedure is as described
keys to select the “DiSEqC 1” menu option.
keys to select the “DiSEqC 1” menu option.
keys to select the “DiSEqC 1” menu option.
keys to select the desired DiSEqC™
four times to exit the menu and return to the TV
screen. This also confi rms the saving of the set value. If you
make an incorrect setting, you will see the message “Poor or no
With cascading switches, a total of 16 satellite positions can be saved
under the “DiSeqC 2” menu option. Horizontal/Vertical and High/Low
give a total of 256 possible settings.
settings should only be made and this kind of system only
very change, you should note the settings on the form at the
erating manual. The satellites listed under the
Factory Satellite Settings
option are preset in the factory
” option are preset in the factory”
option are preset in the factory. option are preset in the factory
To date, the LNB supply voltage of 14/18 V and the 22 kHz signal
(superimposed on the LNB supply voltage) have been suffi cient for
signal selection for most applications. These four switching signals
allow you to switch between the horizontally and vertically polarised
signals and between two satellites (multi-feed reception).
