12
Insignia NS-WHP314 2.4 GHz Digital Wireless Stereo Headphones
www.insigniaproducts.com
If the power indicators on the headphones and docking station
continue to blink after 30 seconds, they are no longer paired to each
other. If this happens, follow these steps:
• Make sure the headphones and docking station are within range of
each other (ideally in the same room).
• Turn off the headphones and the docking station.
• Turn on both the headphones and the docking station. The lights
will initially blink, then they should turn on steady.
Listening to your digital wireless stereo headphones
To listen through the headphones:
1 Turn on the headphones and docking station. Make sure that your
docking station and headphones are wirelessly paired. See “Using the
headphones” on page 11.
2 Set the headphone volume level to the minimum.
3 Put your headphones on your head. Adjust the fit until you feel
comfortable.
4 Turn on your audio source and begin playback. Depending on the
audio source, you may need to turn up the volume on the audio
source.
5 Adjust the headphone volume to your normal listening level.
Note
If the charge on the headphone batteries is low, the Power/
Pairing indicator on the headphones blinks red. When this
happens, you should charge the headphones. For instructions,
see “Charging the headphones“ on page 10.
Caution
Continuous use at high volume may permanently damage your
hearing.
Note
If the system is connected to a TV, you may want to turn off the
TV sound to prevent hearing sound from the TV speakers. Refer
to your TV manual.
NS-WHP314_14-0122_MAN_V1_ENG.fm Page 12 Friday, April 4, 2014 8:56 AM
