To skip unwanted channel
Manual Fine Tuning
To restore a skipped channel
Tuning in
After presetting the channels, you can skip unwanted channels
so that only the channels you want to watch are selected with
Channel up/down buttons.
1
1
2
2
Select the unwanted channel with channel select buttons.
Or p ress M ENU bu tto n
repeatedly to display Search
menu, press CH-
ress V-
or CH+ to
select Channel menu item,
p or V+ to select the
unwanted channel.
Select the channel you want to fine-tune.
Enter into Search menu, press
CH-
ress and hold V-
or CH+ to select Fine Tune,
then p or V+, the
channel begins fine tuning until
the best possible picture and
sound is achieved.
(Press V+ to fine-tune
upward. The AFT function will be set to OFF mode
automatically)
V- to fine-tune downward, while
Use direct channel select buttons (0-9) to select the channel
you want to restore. Enter into Search menu, press CH-
ress V-
or CH+
to select Skip, p or V+ to select Skip Off.
Press
ress V-
CH- or CH+ to select Skip,
p or V+ to select Skip ON.
Thus, after exiting the menu, the channel will then be skipped
when you select programs with the Channel up/down button.
If you want to skip other unwanted channels, repeat steps
above to change the channel number.
Note: you can select the skipped channel by pressing the
direct channel select buttons.
Fine tuning is not necessary under normal conditions. However,
in area of inferior broadcast conditions where adjustment is
necessary for a better picture and sound, use Fine tuning.
13
Search
Signal Input
Channel
Skip
Auto Search
Fine tune
Air
28
On
Press V+
0
Search
Signal Input
Channel
Skip
Auto Search
Fine tune
Air
28
Off
Press V+
-5
Auto Fine Tuning (AFT)
If picture and sound's effect of the channel is instead poor by making use of Fine Tune, you can correct them by
making use of AFT.
1
2
Enter into Search menu, press CH- to select AFT.
P or V+ to select AFT On.ress V-
Search
Channel
Skip
Auto Search
Fine tune
28
Off
Press V+
-5
AFT On
Menu control buttons
Direct channel
select buttons
DSP
TV/AV
CCD
DSP
MUTE
1 2 3
4 5 6
7 8 9
0
SCAN
P
CH+
MENU
CH-
V- V+
STEREO
* To exit the menu, press DSP button or
repeatedly press MENU button.
