2
6. Using a wire cutter, cut the three zip-ties that secure the calf massager cable harness to the calf massager. Note the location of the zip-ties as you will need to
install new zip ties in the same location after installing the new calf massager motor.
7. Using a Phillips-head screwdriver, remove the six screws that secure the calf massager motor to the frame (Fig.5).
8. Remove the calf massager motor from the frame (Fig.5).
(Fig.5)
Calf massager motor
1. Place the new calf massager motor into position, then replace the six screws to secure it to the frame.
2. Using new zip-ties, secure the calf massager cable harnesses in the same location as they were secured previously.
3. Place the calf massager cover into position, then replace the four screws to secure it.
4. Close the calf massager zipper.
5. Pull up on the calf massager rotation release handle, then rotate the calf massager until the massager side is facing upward.
6. Plug in the chair, power it on, then verify that the calf massager is working properly
INSTALLING THE NEW CALF MASSAGER MOTOR
Please send any questions or comments regarding these instructions to: documentation@humantouch.com
© 2012 Human Touch
®
, LLC.
