The take-up reel is operated from the front panel.
Follow these guidelines when taping rolls to the take-up reel spindle core:
●
Make sure that the paper is straight when it is attached to the spindle core. Otherwise it skews as
it winds onto the core.
●
The spindle core on the take-up reel must be the same width as the paper that you are using.
●
Check that neither side of the spindle core has end caps, and make sure the spindle core is
pushed firmly into both spindle guides.
●
If you are using a Z6200 1.1m printer, make sure that the bin loop is placed behind the foot
brace so that it does not block the take-up reel sensors.
NOTE: If you want to load the take-up reel during printing, familiarize yourself with the procedural
steps. Loading the take-up reel during printing requires you to complete the procedure while the printer
is feeding and printing paper. Loading the take-up reel during printing saves approximately 1 m (3 ft)
of paper.
Load a roll onto the take-up reel
1.
On the printer's front panel, select the
icon, and then select Paper load > Load take-up
reel.
2. If you want to load the take-up reel now, select Load take-up reel now on the front panel. If
you want to load the take-up reel during printing, select Load it during printing on the front
panel.
3.
Make sure that the loading table is in its upright position.
38 Chapter 4 Handle the paper ENWW
Handle the paper
