A SERVICE OF

logo

Removal and replacement procedures 55
6. Perform the post-installation procedure.
System fan
The server has one system fan located on the chassis back panel wall.
A new system fan can be installed to allow the server to operate properly in case the default system
fan becomes defective.
To replace the system fan:
1. Perform the pre-installation procedure.
2. Remove the defective system fan:
a. Disconnect the fan cable from its system board connector (1).
b. Remove the four screws on the rear panel (2)
c. Grasp the fan by the two handles, and lift it up from the chassis (3).