A SERVICE OF

logo

EN
Unit of Measure Command
4-15
Figure 4-6 Cursor Moves at Different Unit of Measure Settings
The printer’s physical
dot size
has
no direct bearing
on the size of
PCL Units
used in cursor movements. In addition, PCL Units are
not
affected by the current control panel or PJL resolution setting.
Note
If no other unit of measure value has been specified, then the default
is one Unit equals 1/300 inch. In this case, a cursor movement of
450 Units moves the cursor 1.5 inches, whether printed at 300 or
600 dpi print resolution.