HP drivers. If set to DISABLED, some non-HP PostScript drivers use the PostScript tray
selection method instead of the HP method.
●
SIZE/TYPE PROMPT. Use this item to control whether the tray configuration message and its
corresponding prompts are shown whenever a tray is opened and closed. These prompts
instruct you to change the type or size if the tray is configured for a different type or size than is
loaded in the tray.
To set Use Requested Tray
1. Press Menu to open the menus.
2.
Press
to highlight CONFIGURE DEVICE, and then press .
3.
Press
to highlight SYSTEM SETUP, and then press .
4.
Press
to highlight TRAY BEHAVIOR, and then press .
5.
Press
to select USE REQUESTED TRAY.
6.
Press
or to select EXCLUSIVELY or FIRST, and then press .
7. Press Menu to exit the menu.
To set Manually Feed Prompt
1.
Press Menu to open the menus.
2.
Press
to highlight CONFIGURE DEVICE, and then press .
3.
Press
to highlight SYSTEM SETUP, and then press .
4.
Press
to highlight TRAY BEHAVIOR, and then press .
5.
Press
to highlight MANUALLY FEED PROMPT, and then press .
6.
Press
or to select ALWAYS or UNLESS LOADED, and then press .
7. Press Menu to exit the menu.
To set the printer default for PS Defer Media
1.
Press Menu to open the menus.
2.
Press
to highlight CONFIGURE DEVICE, and then press .
3.
Press
to highlight SYSTEM SETUP, and then press .
4.
Press
to highlight TRAY BEHAVIOR, and then press .
5.
Press
to select PS DEFER MEDIA.
6.
Press
or to select ENABLED or DISABLED, and then press .
7. Press Menu to exit the menu.
ENWW Changing printer-control-panel configuration settings 37
