A SERVICE OF

logo

60 HP BladeSystem p-Class Enclosure Installation Guide
7. Be sure that the server blade enclosure DC power LEDs are illuminated
green. Refer to "LEDs, buttons, and switches (on page 63
)" or to the
documentation included with the HP BladeSystem p-Class Server Blade
Enclosure.
Power is now applied to all system hardware.
Powering up the system (HP BladeSystem p-Class 3U Power
Enclosure)
If you have installed the HP BladeSystem p-Class 3U Power Enclosure:
1. Be sure all power supplies are seated in the power enclosure.
2. Connect the power cords to the AC power source.
3. Apply power to the facility power connection, if necessary.
4. Unlock the circuit breakers on the power enclosure.
5. Toggle the switches to the on position. This action applies AC power to the
hot-plug power supplies.
6. Lock the switch in the on position.