Grizzly G0725 Manual

A SERVICE OF

next previous

"'-"

BdYZa<%,'*B[\#H^cXZ%.$&&

To surface plane on the jointer:

1. GZVY VcY jcYZghiVcY SECTION 1:

SAFETY#

2. BV`Z hjgZ ndj ^cheZXi ndjg ldg`e^ZXZ [dg

YVc\Zgdjh XdcY^i^dch Vh YZhXg^WZY ^c i]Z

Choosing and Jointing Stock dcPage 26#

3. HZii]ZXjii^c\YZei][dgndjgdeZgVi^dc#LZ

hj\\Zhi

&

¿('[dghjg[VXZeaVc^c\#

4. BV`ZhjgZndjg[ZcXZ^hhZiid.%ß#

5. >[ndjgldg`e^ZXZ^hXjeeZYlVgeZY!eaVXZ

i]Z XdcXVkZ h^YZ hZZ Figure 35 dc Page

27[VXZ Ydlcdc i]Zhjg[VXZd[ i]Z^c[ZZY

iVWaZ#

6. HiVgii]Z_d^ciZg#

Edge Jointing

I]ZejgedhZd[ZY\Z_d^ci^c\^hidegdYjXZV[^c"

^h]ZY![aVi"ZY\ZYhjg[VXZhZZFigure 37hj^iVWaZ

[dg_d^cZgndg[^c^h]^c\#>i^hVahdVcZXZhhVgnhiZe

l]ZchfjVg^c\gdj\]dglVgeZYhidX`#

Figure 38#>aajhigVi^dcd[ZY\Z_d^ci^c\gZhjaih#

Figure 37#:mVbeaZe]didd[Vine^XVa_d^ci^c\

deZgVi^dc#

NOTICE

If you are not experienced with a jointer,

set the depth of cut to zero, and practice

feeding the workpiece across the tables as

described below. This procedure will better

prepare you for the actual operation.

7. L^i]V ejh]WadX` ^cZVX] ]VcY!egZhh i]Z

ldg`e^ZXZ Ydlc dc i]Z ^c[ZZY iVWaZ VcY

V\V^chi i]Z [ZcXZ l^i] [^gb egZhhjgZ! i]Zc

[ZZY i]Zldg`e^ZXZ dkZgi]Z XjiiZg]ZVY!Vh

h]dlc^cFigure 37#

 Note:If your leading hand (with push block)

gets within 4" of the cutterhead, lift it up and

over the cutterhead, and place the push

block on the portion of the workpiece resting

on the outfeed table. Now, focus your pres-

sure on the outfeed end of the workpiece

while feeding, and repeat the same action

with your trailing hand when it gets within 4"

of the cutterhead. DO NOT place either hand

closer than 4" from the cutterhead! Failure

to heed this warning could result in serious

personal injury.

8. GZeZViStep 7jci^ai]ZZci^gZhjg[VXZ^h[aVi#

Failure to use push blocks when surface

planing may result in cutterhead contact

with your hands, which will cause serious

personal injury. Always use push blocks to

protect your hands when surface planing

on the jointer.