A SERVICE OF

logo

Open as PDF
next previous
FORWARD-FACING INSTALLATION WITH VEHICLE SEAT BELTS
18
1
4
3
2
Store LATCH belt by attaching to connectors
through rear-facing openings
(see page 31, fig. j
s!TTACHCONNECTORSTOSTORAGEBARONEACH
side (fig. a).
s!DJUST
LATCHBELTTOREMOVEEXCESSSLACK
by pulling adjustment belt.
Adjust car seat to upright position (see fig. b
and page 25, fig. g3ECURERECLINE
STANDINTO5PRIGHT0OSITIONBYPUSHINGTABS
INTOLOCKPOSITION
Place
forward-facingONVEHICLESEAT
3LIDECHILDRESTRAINTBACKUNTILTHERESTRAINTISIN
CONTACTWITHTHEVEHICLESEATBACK
4HREADVEHICLESEATBELTTHROUGHOPENINGS
(fig. c).
0RESSDOWNlRMLYINCENTEROFCHILDRESTRAINTTO
COMPRESSVEHICLESEATCUSHIONWHILETIGHTENING
VEHICLESEATBELT
5SEYOURKNEETOPRESSDOWNINCENTEROF
child restraint (fig. d).
0ULLFRONTTOBACKANDLEFTTORIGHTATBELTPATH
TOCHECKFORSECUREINSTALLATION(fig. e)4HE
CHILDRESTRAINTSHOULDNOTMOVESIDETOSIDEOR
FORWARDMORETHANINCHCM6EHICLELAP
belt MUST stay tight.
If not secure, see “Vehicle Seat Belts” page 32.
!TTACHTETHERSTRAPHOOK(A) to anchor
hardware (B) and tighten adjustment belt to
REMOVEANYSLACK(fig. f))FVEHICLEDOESNOT
HAVEANCHORPOINTSTOATTACHTETHERHOOK
TETHERHOOKSHOULDBESTOREDSEEh4ETHER
Storage”, page 38.
Belt must lay flat and not be twisted.
0ERFORMTHISTESTEVERYTIMEYOUDRIVEWITHYOUR
child.
WARNING
LATCH belt MUST be stored when
using vehicle seat belt to install
child restraint.
6
5