Proper Lifting of Unit
309535L 11
Proper Lifting of Unit
Either remove the cart handle or secure it to the cart
before lifting the unit. Connect a bridle swing, hooking
an end to each of the Xtreme Mix air motor rings. Hook
the center ring on a hoist. See F
IG. 5. Carefully lift the
Xtreme Mix unit; make sure it balances evenly.
Setup
WARNING
Follow instructions below to avoid dropping or swing-
ing unit or being struck by the cart handle, which can
cause serious injury or damage to equipment.
F
IG. 5
WARNING
Do not install equipment approved only for non-haz-
ardous location in a hazardous area. Substitution of
components may impair intrinsic safety. Read warn-
ings, page 5. Ground equipment as instructed below.
If connecting PC for data download, PC must be in
non-hazardous location and a safety barrier must be
installed. See Xtreme Mix software documentation.
ti2319a
1. Grounding: Connect Xtreme Mix ground wire clamp
(G) to a true earth ground.
2. Model 248842 Only: This model uses a remote mix
manifold, which is connected to the unit by at least
50 ft. (15 m) of individual fluid hoses. Refer to manu-
als 310794 and 310797 for typical setups.
All Other Models: The 50 ft. (15 m) fluid hose (W),
static mixer (X), whip hose (Y), and gun (Z) come
assembled. Note the order of connection.
G
ti2218a
CAUTION
Do not assemble static mixer (X) directly to fluid man-
ifold. Install static mixer after first 50 ft. (15 m) of hose
to ensure material is completely mixed. Spraying
unmixed material could necessitate rework of part
sprayed.
WX Z Y
