A SERVICE OF

logo

Open as PDF
next previous
24
Chapter 3: Setting Up the Autoloader
www.gateway.com
Securing the autoloader
To secure the autoloader to the cabinet:
1 From the front of the cabinet, position the autoloader on the shelf flanges
between the support rails. Slide the autoloader toward the back of the
cabinet until the brackets contact the cabinet’s mounting holes. Make sure
that the tabs on the back of each shelf flange are fully engaged in the slots
at the back of the autoloader.
2 Place one screw from the cabinet mounting kit into the hole in the front
of each bracket. If your cabinet has square mounting holes, or the holes
are larger than the screws provided in the kit, use the clip-nuts to secure
the screws. Use a #2 Phillips screwdriver to tighten the screws.
P
O
WE
R
M
E
N
U
-
+
S
E
L
E
C
T