9 - AUX PAGES
176
190-00357-00 Rev H
Utility Page
available on the GTN but not on the GNS in these cases.
The GNS will fly the procedure as it normally would if
Crossfill were not active. Once a leg type is reached that
is supported on both the GTN and GNS systems, the sys-
tems will automatically sync to the same leg.
Waypoint names longer than six characters, or dupli-
cates, sent from the GTN unit to the GNS unit will replace
some characters with a “+” sign, while leaving significant
characters to aid in identification (such as, USR003 becomes
US+003).
To Enable Flight Plan Crossfill from the GTN Unit
1. From the Default NAV Page, Active Flight Plan
page, or the User Waypoint page press MENU.
Highlight “GTN Crossfill?” and then press ENT.
OR
2. On the Aux Flight Planning page scroll down
to “Manual GTN Crossfill” with the large or
small right knob, and then press ENT.
3. With the Link field highlighted, turn the small
right knob to show “Enabled”, and then press
ENT. This enables the GNS unit to receive flight
plan information from the GTN unit.
CAUTION: The user is required to always verify each
flight plan leg prior to navigating with the GNS unit
when Manual GTN Crossfill is active.
NOTE: If the user manually alters the flight plan on
the GNS unit, the systems will not crossfill until the
pilot activates the feature again on the GNS unit.
To Transfer GNS User Waypoints to the GTN Unit
1. Continuing from the steps above, turn the
large right knob to highlight “Initiate Trans-
fer?.”
2. Press ENT. The 400W/500W-series unit’s User
waypoints will be sent to the GTN unit.
