Returning the Server to Operation 179
Note – As soon as the power cords are connected, standby power is applied.
Depending on how the firmware is configured, the system might boot at this time.
Related Information
■ “Power On the Server Using the poweron Command” on page 179
■ “Power On the Server Using the Front Panel Power Button” on page 180
▼ Power On the Server Using the
poweron Command
Note – If you are powering on the server following an emergency shutdown that
was triggered by the top cover interlock switch, you must use the poweron
command.
● Type poweron at the service processor prompt.
You will see an -> Alert message on the system console. This message indicates
that the system is reset. You will also see a message indicating that the VCORE has
been margined up to the value specified in the default .scr file that was
previously configured. For example:
Related Information
■ “Power On the Server Using the Front Panel Power Button” on page 180
-> poweron
-> start /SYS
