A SERVICE OF

logo

Open as PDF
next previous
8
Flipper
Mullion
Hinge
Screw
Flipper
Mullion
Adjusting Flipper Mullion Screw
To adjust the ipper mullion:
1 Loosenthescrewlocatedontheipper
mullion hinge.
2 Adjustippermullionheight.Forproper
connectionwiththeippermullionguide,
there should be a separation about the
thickness of a coin (0.060 inches, or
1.5mm)betweentheguideandipper
mullion.
3 Retighten screw.
4 Lift the door while adjusting the washer.
To raise the door, rotate washer clockwise
(when viewed from the bottom). To lower
door, rotate washer counterclockwise
(when viewed from the bottom).
5 Re-tighten the screw (where applicable),
ensuring it is between the spokes of the
washer. Screw will not be tight, just insert
untilitisushwiththehinge.
Mullion
Guide
Flipper
Mullion
Thickness
of a Coin
Adjusting Flipper Mullion Height
Door
Lower
Door
Hinge
Washer
Raise
Door
Raising/Lowering Door
Screw (where applicable)
Hinge
Washer Spokes
Screw
Retighten Screw
NOTE
If after adjusting doors higher the door
makes a popping/clicking sound, remove
screw and replace with the longer one
supplied in the handle package (select
models).
INSTALLATION