A SERVICE OF

logo

Open as PDF
next previous
31
CHANGING THE FILTER
Locating the Filters
Yourrefrigeratorisequippedwithwaterltering
system.Thewaterltersystemltersall
dispensed drinking water, as well as the water
used to produce ice.
Water Filter
Thewaterlterislocatedatthetoprightsideof
the fresh food compartment.
Ordering Replacement Filters
Toorderyourreplacementlters,pleasevisitour
online store at www.frigidaire.com/store, by calling
toll-free at 877-808-4195, or by visiting the dealer
where you purchased your refrigerator. Frigidaire
recommendsthatyouorderextralterswhenyou
rstinstallyourrefrigerator,andthatyoureplace
yourltersatleastonceeverysixmonths.
Hereistheproductnumbertorequestwhen
ordering:
PureSource Ultra
TM
Water Filter
Part #ULTRAWF
Replacing the Water Filter
Ingeneral,youshouldchangethewaterltereverysix
monthstoensurethehighestpossiblewaterquality.
Water Filter Status on the user interface prompts
youtoreplacethelterafterastandardamountof
water (200 gallons/757 liters for PureSource Ultra
TM
)
hasowedthroughthesystem.
If your refrigerator has not been used for a period
of time (during moving for example), change the
lterbeforereinstallingtherefrigerator.
Filter Cartridge
Do not use with water that is microbiologically
unsafeorofunknownqualitywithoutadequate
disinfection before or after the system. Systems
certiedforcystreductionmaybeusedon
disinfectedwatersthatmaycontainlterablecysts.
Test & certication results:
• Rated Capacity - 200 gallons/757 liters for
PureSource Ultra
TM
iceandwaterlter
• Ratedserviceow-.50gallonsperminute
• Operating Temp: Min. 33° F, Max. 100° F
• Maximum Rated Pressure - 100 pounds per
squareinch
• Recommended Minimum Operating Pressure:
30poundspersquareinch
To replace your PureSource Ultra
TM
water lter:
It is not necessary to turn the water supply off
tochangethelter.Bereadytowipeupany
smallamountsofwaterreleasedduringthelter
replacement.
1 Turn Off the ice maker power switch.
2 Removethelterbypushingontheend/face
ofthelter.
3 Slidetheoldwaterltercartridgestraightout
of the housing and discard it.
4 Unpackagethenewltercartridge.Using
the alignment guide, slide it gently into the
lterhousinguntilitstopsagainstthesnap-in
connector at the back of the housing.
5 Pushrmlyuntilthecartridgesnapsinto
place (you should hear a click as the cartridge
engages the snap-in connector).
6 Press a drinking glass against the water
dispenser while checking for any leaks at the
lterhousing.Anyspurtsandsputtersthat
occur as the system purges air out of the
dispenser system are normal.
7 Afterllingoneglassofwater,continue
ushingthesystemforaboutfourminutes.
8 Turn On the ice maker.
9 Press and hold the Water Filter button on the
Ice & Water Dispenser control panel for three
seconds. When the display changes from Red
to Green, the status has been reset.
The PureSource Ultra
TM
ice and
waterltersystemistestedand
certiedtoNSF/ANSIStandards42and
53forthereductionofclaimsspecied
on the performance data sheet.
More about your Advanced Water
Filter
NOTE
Whenorderingyourreplacementlter,please
reorderthesameltertypethatiscurrentlyin
your refrigerator.