16
CHANGING THE FILTER
More about your Advanced Water Filter
The PureSource Ultra
TM
ice and water
ltersystemistestedandcertiedbyNSF
International, to NSF/ANSI Standards 42
and53forthereductionofclaimsspecied
on the performance data sheet.
Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection
beforeorafterthesystem.Systemscertiedforcyst
reduction may be used on disinfected waters that may
containlterablecysts.
Test & certication results:
• RatedCapacity-200gallons/757litersfor
PureSource Ultra
TM
iceandwaterlter
• Ratedserviceow-.50gallonsperminute
• OperatingTemp.:Min.33°F,Max.100°F
• MaximumRatedPressure-100poundsper
square inch
• RecommendedMinimumOperatingPressure:30
pounds per square inch
To replace your PureSource Ultra
TM
water
lter:
It is not necessary to turn the water supply off to
7 Afterllingoneglassofwater,continueushing
the system for about three minutes.
8 Turn On the ice maker.
9 Press and hold the Filter Status button on the Ice
& Water Dispenser control panel for three seconds.
When the display changes from “Replace” to
“Good,” the status has been reset.
changethelter.Bereadytowipeupanysmallamounts
ofwaterreleasedduringthelterreplacement.
1 Turn Off the ice maker.
2 Removethelterbypushingontheend/faceof
thelter.
3 Slidetheoldwaterltercartridgestraightoutof
the housing and discard it.
4 Unpackagethenewltercartridge.Usingthe
alignmentguide,slideitgentlyintothelter
housing until it stops against the snap-in connector
at the back of the housing.
5 Push rmly until the cartridge snaps
into place (you should hear a click as the
cartridge engages the snap-in connector).
6 Press a drinking glass against the water dispenser
whilecheckingforanyleaksatthelterhousing.
Any spurts and sputters that occur as the system
purges air out of the dispenser system are normal.