A SERVICE OF

logo

Open as PDF
next previous
25
CHANGING THE FILTER
Locating the Filters
Yourrefrigeratorisequippedwithwater
lteringsystem.Thewaterltersystemlters
all dispensed drinking water, as well as the
water used to produce ice.
Water Filter
Thewaterlterislocatedatthetoprightside
of the fresh food compartment.
Ordering Replacement Filters
Toorderyourreplacementlters,pleasevisit
our online store at www.frigidaire.com/store,
by calling toll-free at 877-808-4195, or by
visiting the dealer where you purchased your
refrigerator. Frigidaire recommends that you
orderextralterswhenyourstinstallyour
refrigerator,andthatyoureplaceyourltersat
least once every six months.
Hereistheproductnumbertorequestwhen
ordering:
PureSource Ultra
TM
Water Filter
Part #ULTRAWF
Replacing the Water Filter
In general, you should change the water
ltereverysixmonthstoensurethehighest
possiblewaterquality.TheWater Filter
Status light on the user interface prompts you
toreplacethelterafterastandardamountof
water (200 gallons/757 liters for PureSource
Ultra
TM
)
hasowedthroughthesystem.The
waterlterstatuslightonthismodelisnot
performancetestedorcertiedbyNSF.
If your refrigerator has not been used for a
period of time (during moving for example),
changethelterbeforereinstallingthe
refrigerator.
Filter Cartridge
Do not use with water that is microbiologically
unsafeorofunknownqualitywithoutadequate
disinfection before or after the system. Systems
certiedforcystreductionmaybeusedon
disinfectedwatersthatmaycontainlterablecysts.
Test & certication results:
• Rated Capacity - 200 gallons/757 liters for
PureSource Ultra
TM
iceandwaterlter
• Ratedserviceow-.50gallonsperminute
• Operating Temp.: Min. 33° F, Max. 100° F
• Maximum Rated Pressure - 100 pounds per
squareinch
• Recommended Minimum Operating Pressure:
30poundspersquareinch
To replace your PureSource Ultra
TM
water lter:
It is not necessary to turn the water supply off
tochangethelter.Bereadytowipeupany
smallamountsofwaterreleasedduringthelter
replacement.
1 Turn Off the ice maker by raising the wire
signal arm.
2 Removethelterbypushingontheend/
faceofthelter.
3 Slidetheoldwaterltercartridgestraight
out of the housing and discard it.
4 Unpackagethenewltercartridge.Using
the alignment guide, slide it gently into the
lterhousinguntilitstopsagainstthesnap-in
connector at the back of the housing.
5 Pushrmlyuntilthecartridgesnapsinto
place (you should hear a click as the
cartridge engages the snap-in connector).
6 Turn On the ice maker by lowering the wire
signal arm.
7 Press and hold the Water Filter button on the
Ice & Water Dispenser control panel for three
seconds. When the display changes from Red
to Green, the status has been reset.
8 Afterreplacingthewaterlterandinorderfor
the ice maker to work properly, it is necessary
toclearairfromwaterltertubing.Onceice
maker begins making ice, allow the bucket to
llcompletely,thendiscardtherstTWOFULL
buckets of ice. It will take at least two days
tocompletelyllthebucketonregularice
making mode or 1½ days on fast ice mode.
The PureSource Ultra
TM
ice
andwaterltersystemistested
andcertiedtoNSF/ANSI
Standards 42 and 53 for the
reductionofclaimsspeciedon
the performance data sheet.
More about your Advanced
Water Filter