A SERVICE OF

logo

Open as PDF
next previous
8


 Loosenthescrewlocatedontheippermullion
hinge.
2 Adjustippermullionheight.Forproper
connectionwiththeippermullionguide,there
should be a separation about the thickness of a
coin (0.060 inches, or 1.5 mm) between the guide
andippermullion.
3 Re-tighten screw.
4 Lift the door while adjusting the washer. To raise
the door, rotate washer clockwise (when viewed
from the bottom). To lower door, rotate washer
counter-clockwise (when viewed from the bottom).
Re-tighten the screw, ensuring it is between the
spokes of the washer. Screw will not be tight, just
insertuntilitisushwiththehinge.



NOTE
If after adjusting doors higher the door makes a
popping/clicking sound, remove screw and replace with
the longer one supplied in the handle package.
