10. Select your printer in the dialog box below and follow the
on-screen instructions.
Note for Windows NT 4.0 users
If your printer does not print correctly as a remote printer, the
following procedure may help you solve the problem.
1. Install the Windows NT 4.0 printer software in your
computer as described on page 2-14.
2. Click
Start
, and select
Settings
and
Printers
.
3. Right-click the icon of your printer, and click
Properties
.
4. Select a printer port other than
LPT1
in the Port menu.
5. From the DOS prompt, type the network path to your printer.
For example, type the following:
C:\net use lpt2: \\epserver\printer
Then press the
Enter
key. If you selected a port other than
“lpt2” in step 4, substitute this port for "
lpt2
" in the
command above. You should also substitute the name of
your print server for "
epserver
", and the name of the
printer, as defined on the print server, for "
printer
".
6. Restart your computer.
Note:
If you need to cancel this setting, follow the instructions above
and type
C:\net use lpt2: /d
in step 5.
Select your printer
fig4
Windows
2
R
Easter10 Ref. Guide
Rev.C
A5 size Chapter 2
1-07-98 DR, pass 3
Getting Started
2-25
