Instruction Manual
760007-A
July 2003
7-20 Appendix A. Menu Displays Rosemount Analytical Inc. A Division of Emerson Process Management
Model NGA2000 PMD
Linearity coefficients
Edit the polynomial coefficients as
desired. Make sure that the curve upper
limit is correct, this is the limit of
the range that this polynomial will
correct.
The status line selects whether the
curve is in use.
HOME
STORE INFO
Calibration Factors
The analyzer uses calibration factors for each
range. You can adjust them while viewing the reading,
to achieve an accurate calibration. Make sure
the factors are correct for the range you are on.
You will not see a change in the reading if you use
the wrong ones, but you’ll find out when you change
the range! You cannot adjust all ranges at the same
time, you must adjust them one by one.
HOME
ESCAPE INFO
nalyzer Parameter List
Primary Variable Parameters
Control mode:
Output delay time:
Range 1 upper limit:
Range 2 upper limit:
Range 3 upper limit:
Range 4 upper limit:
Range 1 lower limit:
Range 2 lower limit:
Range 3 lower limit:
000.0
000.0
000.0
000.0
000.0
000.0
000.0
000.0
000.0
HOME
ESCAPE INFO
NEXT
BACK
Menu: 57 LINRANGE1l1
Menu: 58 CALFACTORSI1
Menu: 59 APARLST2
