Dual XDMA7715 Manual

A SERVICE OF

next previous

2

TYPICAL FRONT-LOAD DIN MOUNTING METHOD

Please read entire manual before installation.

Before You Start

•Disconnectnegativebatteryterminal.Consultaqualifiedtechnicianforinstructions.

•Avoidinstallingtheunitwhereitwouldbesubjecttohightemperatures,suchasfrom

directsunlight,orwhereitwouldbesubjecttodust,dirtorexcessivevibration.

Getting Started

•Removetrimringfromunit,

•Remove2transitscrewslocated

ontopoftheunit.

•Insertthesuppliedkeysintothe

slotsasshown,andslidetheunit

outofthemountingsleeve.

•Installmountingsleeveinto

opening,bendingtabstosecure.

•Connectwiringharnessand

antenna.Consultaqualified

technicianifyouareunsure.

•Certainvehiclesmayrequirean

installationkitand/orwiring

harnessadapter(soldseparately).

•Testforcorrectoperationandslide

intomountingsleevetosecure.

•Snaptrimringintoplace.

•Mounttheiplug™adaptertoany

smoothcleansurfaceusingthe

supplieddouble-sidedtapeor#2x

3/8”Phillipsheadscrews.

XDMA7715 INSTALLATION

Preparation