xStack
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
255
DGS-3426P:5#show iproute static
Command: show iproute static
Routing Table
IP Address/Netmask Gateway Cost Protocol Backup Status
------------------ ------------- ----- -------- -------- --------
10.0.0.0/8 10.1.1.255 1 Static Primary Inactive
Total Entries : 1
DGS-3426P:5#
create ipv6route
Purpose Used to create IPv6 route entries to the Switch’s IP routing table.
Syntax
create ipv6route [default |<ipv6networkaddr>] [<ipif_name 12> <ipv6addr>|
<ipv6addr>] {<metric 1-65535>}
Description This command is used to create an IP route entry to the Switch’s IP routing table.
Parameters default– Use this parameter to create a default static IPv6 route entry in the Switch’s IP
routing table.
<ipv6networkaddr> − IPV6 address and netmask of the IP interface that is the destination
of the route. Specify the address and mask information using the format as ipv6address /
prefix_length (ipv6address is hexadecimal number, prefix length is decimal number, for
example 1234::5D7F/32).
<ipif name 12> − Enter the corresponding IPIF name of the IPv6 addres.
<ipv6addr> − IPv6 address for the next hop router.
<metric 1–65535> − Allows the entry of a routing protocol metric entry, representing the
number of routers between the Switch and the IP address above. The default setting is 1.
Restrictions Only Administrator and Operator-level users can issue this command.
Example usage:
To add a single static IPv6 entry in IPv6 format:
DGS–3426:5#create ipv6route 1234::5D7F/32 2D30::AC21
Command: create ipv6route 1234::5D7F/32 2D30::AC21
Success.
DGS–3426:5#
