1
Press the ZONE2 SELECT button to display the
“ZONE2 SOURCE” on the display.
2
Turn the FUNCTION knob to select the source
you want to output appears on the display.
3
Start playing the source to be output.
For operating instructions, refer to the manuals of the
respective components.
1
Press the ZONE3/REC SELECT button to
display the “ZONE3 SOURCE” on the display.
• The MULTI indicator light.
The display switches as follows each time the button
is pressed.
2
Turn the FUNCTION knob to select the source
you want to output appears on the display.
3
Start playing the source to be output.
For operating instructions, refer to the manuals of the
respective components.
• The signals of the source selected in the ZONE3 mode are
also output from the VCR-1, VCR-2, VCR-3 and CDR/TAPE
recording output terminals.
• Digital signals are not output from the ZONE2 and ZONE3
audio output terminals.
• About the MULTI ZONE connections ( page 90, 91).
• Digital outputs of the OPTICAL2, 3 and 4 OUT normally
switch in association with the ZONE3/REC SELECT mode,
but if “ZONE2 SELECT” is selected at “Digital Out Assign”,
the source switches in association with the “ZONE2
SELECT” mode for the OPTICAL2 OUT digital output
terminal ( page 121).
Outputting a program source to an
amplifier, etc., in a ZONE2 room
(ZONE2 SELECT mode)
Outputting a program source to an
amplifier, etc., in a ZONE3 room
(ZONE3 SELECT mode)
