Installation Instructions Model: PAC-500
3
TOOLS REQUIRED FOR INSTALLATION
• Stud Sensor
• Level
• Saw
• Tape Measure
• Screwdriver (for wood screws)
• 9/16" Wrench
• 3/16" Hex Key (provided)
• 4mm Hex Key (provided)
• 4mm Hex Bit (provided)
NOTE: Other tools may be required depending on your
method of installation.
PARTS
After unpacking carton, inspect and verify contents (See
Figure 1). If any listed parts are missing or damaged,
contact Chief Customer Service at 1-800-582-6480.
Figure 1: Parts
Table 1: Parts
Item Description Qty
10 HOUSING, In-Wall 1
20 BRACKET, Upper 1
30 BRACKET, Lower (MWR/PWR only) 1
40 BRACKET, Lower (PNR only) 1
50 MOULDING, Vertical 2
60 MOULDING, Horizontal 2
70 SCREW, Button Head Cap, 5/16"-18 x 3/4" 4
80 SCREW, Button Head Cap, 3/8"-16 x 5/8" 4
90 SCREW, Flat Head Cap, 3/8"-16 x 3/4" 2
100 BOLT, Connector, 7mm x 40mm 12
110 WASHER, Flat Machine Screw, 1/4" 4
120 WASHER, Lock, Split, 5/16" 4
130 WASHER, Lock, Split, 3/8" 4
140 PAD, Felt, 1/8" thick 2
150 TAPE, Foam, Square 18
160 COVER, White, 9/16" diameter 4
170 KEY, Hex, 3/16" (slightly larger than 180 below) 1
180 KEY, Hex, 4mm 1
190 BIT, Hex, 4mm 1
200 SHIM, Engineered Wood (package; not shown) 1
201 KEY, Hex, 7/32" 1
SUPPORT BLOCKS, wood 2x4, 8" long
(required, not supplied)
8
HORIZONTAL FRAMING, wood 2x4, 14-1/2"
long; exact length dependent upon specific
installation (required, not supplied)
4
SCREW, Wood, #10 x 2-1/2"
(required, not supplied)
40
ELECTRICAL BOX (optional, not supplied) 1
GROMMET (optional, not supplied) 1
10
20
30
40
60
50
90
100
110
201
140
150
160
170
180
190
70
80
120
200
130
