1. Locate battery compartment underneath humidifier. Remove the plastic protective
strip from the LCD support batteries.
2. Turn Water Tank upside down and unscrew Water Tank Cap.
3. Fill Water Tank with cool water. DO NOT fill water all the way to rim.
DO NOT use hot water. Use cool tap water.
DO NOT add any medication, essential oils, or salt.
4. Screw Water Tank Cap back onto Water Tank. Turn the Water Tank over and place
on Water Basin, making sure it fits perfectly.
Note: Do not attempt to move the humidifier while Water Tank is placed on Water
basin. Doing so may cause leakage of water and/or Water Basin to overfill.
5. Connect the adapter cord into the 18V DC opening in the back of the humidifier base.
Connect the power adapter to a 120V outlet.
6. Press Power / Cancel button on front of Water Basin to turn on. The LCD Display will
illuminate and the mist will begin to emit. Turn the Nozzle 360⁰ to adjust mist
output.
7. Press Power / Cancel button again to turn off.
SETTING THE CLOCK
As soon as the humidifier is connected to the power source, the LCD display on the clock
will illuminate blue.
1. Press the FLOW / SET button and hold until the first two numbers blink.
2. Press the LIGHT / FUNCTION button to adjust the correct hour.
3. Press the FLOW / SET button again and the last two numbers will blink.
4. Press the LIGHT / FUNCTION button to adjust the correct minutes.
5. Press the FLOW / SET button several times until the correct clock time appears
on display.
NOTE: You will need to press through other functions until the clock time you
set appears.
PERSONAL HUMIDIFIER FEATURES
Automatic Shut-Off
As soon as the water in the water tank runs low, the humidifier will automatically switch
off. The LCD Clock will remain on.
Adjusting Mist Output
1. As soon as the humidifier is switched on, it will operate on the high setting (5
bars will show on the right side of display).
2. Press the FLOW / SET button to reduce output (The bars will disappear on the
right side of display).
3. The output will be reduced and less mist will be emitted into the air.
4. To increase the output, press the FLOW / SET button again.
LED Nightlight
Press the LIGHT / FUNCTION button to activate backlight of the display. Pressing the
LIGHT / FUNCTION button again will turn on the LED nightlight. Pressing the FUNCTION
button a third time will turn off the display backlight and LED nightlight.
