User Command Specifications
9．Details of command RANGE PROG
RANGE PROG
RANGE PROG
RANGE□PROG
r:PROG=I, <Setting option 1>, <Setting option 2>, …, <Setting option n>
-1
A "busy" response is given while the zoom or focus lens is being driven.
With some input signals, it may not be possible to make this inquiry.
-2
> RANGE PROG
< r:PROG=I, 0, 1, 2
* Commands are indicated by ">", and responses are indicated by "<".
Supported Command State
OFF ON PM
× ○ ×
× ○ ×
* If the command cannot be supported, 'INVALID_MODE,' 'NOT_POWER_SUPPLIED' or 'INVALID_SOURCE' is returned as an error response.
* If the necessary signals are not input, 'INVALID_SIGNAL (*****)' or 'NO_SIGNAL' is returned.
* "i:BUSY" may be returned if the power status is being switched.
Command
supported
SX60 X600SX50 SX6
○○○○
Control Setting Reference
For all other responses, refer to "Error List."
Progressive setting option reques
ID
Mode
Commands
Function
Format
Example
Description
Response
This inquires about the parameter options which enable the progressive setting to be selected.
01.00** 01.01** 01.01** 01.01**
This inquiry can be made when the projector is in both the remote mode and power-on status
at the same time.
(Refer to the ZCONTDRV command and FCONTDRV command.)
The progressive setting can be selected by the PROG command.
Model Power
Input Mode
Remote Local
Remarks
D-RGB A-RGB1 A-RGB2 Comp Video S-Video D-Video SCART None
SX50
×××○○○––×○ ×
SX6
×××○○○×××○ ×
SX60
X600
PAGE 144
