Setting the Time Code
92
NOTES
• The frames value of the time code runs from 0 to 23 (frame rate set to 23.98P) or from 0 to 29 (all other frame
rates).
• However, when [¤ TC/UB Setup] > [Time Code] > [XF Legacy Sync] is set to [On], even when
the frame rate is set to 23.98P, the frames value of the time code output from the TIME CODE terminal will run
from 0 to 29.
• When you are using interval recording, frame recording or slow & fast motion recording mode, you cannot
select the [Free Run] running mode. Conversely, when you are using pre-recording mode and when the movie
format is set to MXF+MP4, [Free Run] is set automatically and cannot be changed.
• When you mix drop frame and non-drop frame time codes, there might be a discontinuity in the time code at
the point where the recording starts.
• When you are using the [Free Run] running mode, the time code will continue running as long as the built-in
rechargeable lithium battery is charged, even if you disconnect all other power sources. However, this is less
accurate than when the camcorder is on.
• If you set an assignable button to [Time Code] (A 129), you can press the button to open the
[¤ TC/UB Setup] > [Time Code] submenu.
C OPY
