Canceling Send Jobs
3-35
Basic Sending
3
Canceling Send Jobs
This section describes the procedure to cancel a transmission in progress.
Canceling Transmission
Follow the procedure below to cancel sending documents during a transmission.
You can also cancel a transmission that has been preset to transmit at a specified
time by deleting the document if you know its transaction number.
1
During transmission, press [Stop].
If you are using Direct Sending, an alarm sounds, and the transmission is
canceled immediately.
If you are using Memory Sending, the message <CANCEL DURING TX/RX?> is
displayed.
If you press (Stop) while the machine is scanning a document placed in the
feeder or during Direct Sending, the message <STOP KEY PRESSED PRESS
OK KEY> is displayed.
2
Press [F3] (YES).
If the machine is scanning the document, or sending the document using Direct
Sending, press (OK).
After you press (YES) to cancel the transmission, an alarm sounds, and a
report automatically prints, unless this feature has been turned ‘OFF.’ (See
“Setting Reports to Print Automatically,” on p. 12-2.)
Scanning or sending stops.
NOTE
•
Sending is not canceled until you press (YES).
•
If you cancel during Direct Sending, you may have to open the feeder cover to
remove your document.
Stop
F3
F4
F3
F3
