30 ELS100-24TXM User Interface ELS100-24TXM
System Configuration Menu
The System Configuration Menu enables modification of system-level
switch configuration parameters. Select
a
from the Main Menu to view the
System Configuration Menu. Figure 3-4 shows the System Configuration
Menu and the accompanying table describes the System Configuration
Menu.
Figure 3-4. System Configuration Menu
SYSTEM CONFIGURATION Access Control: READ/WRITE
a. SNMP Configuration Menu
b System Name
c. System Location
d. System Contact
e. IP Address 000.000.000.000
f. Subnet Mask 000.000.000.000
g. Default Gateway 000.000.000.000
h. BootP/DHCP Enable Yes
i. Screen Timeout (minutes) 0
j. Password None
k. Terminal Baud Rate 9600
l. Terminal Hardware Flow Control No
x. Previous Menu
Enter Selection:
Selection Description
SNMP Confi
uration Menu Menu for confi
urin
SNMP-related parameters.
System Name The switch administrative name (1-36 character ran
e).
System Location The physical switch location (1-36 character ran
e).
System Contact The switch contact person (1-36 character ran
e).
IP Address The IP address of the switch.
Subnet Mask Subnet mask associated with the switch IP address.
Default Gateway The default
ateway (or router) to which the switch sends
IP packets destined for a different subnet.
BootP/DHCP Enable Allows you to enable (Yes) or disable (No) the BootP and
DHCP protocols for automatically confi
urin
the
switch’s IP address information.
Screen Timeout (minutes) The duration of time before a serial console or Telnet
session terminates due to user inactivity (0-65535 nu-
meric ran
e). A value of “0” means that the screen will
not terminate at any time.
Password Allows “read/write” access to the user interface, via the
serial console or Telnet (1-10 character ran
e).
Terminal Baud Rate Serial console baud rate (2400, 9600 or 19200).
Terminal Hardware Flow
Control
Allows you to enable (Yes) or disable (No) hardware flow
control on serial console interface. Si
nals DTR, RTS
and CTS are used for this purpose. Flow control should
be enabled if usin
external modem.
