A SERVICE OF

logo

CSX200 Installation Guide 5-1
5
Troubleshooting
Use this chapter in conjunction with the LANVIEW status monitoring and diagnostic LEDs on the
CSX200 to diagnose power failures, collisions, cable faults and link problems. Figure 5-1 shows
the front panel LEDs. Table 5-1, Table 5-2, Table 5-3, Table 5-4, and Table 5-5 describe LED
states.
If you are having difficulty installing and configuring the CSX200, take the following steps:
Review your CSX200 QuickSTART Guide to insure proper installation.
Check that all cables and connectors have been attached properly.
Verify that power has been attached.
Figure 5-1 CSX200 Front Panel LEDs
Table 5-1 CSX200 Hardware LED States
LED Color State
Power (PWR)
OFF Power Off
GREEN Power is on
Processor (CPU)
OFF Power Off
RED Fault condition detected
GREEN (blinking) NORMAL
Power
CPU
Collision
Receive
Link
Transmit
Receive
Link
Status 1
Status 2
Test
2012_06
STS 1
STS 2