Base Unit Charger
AC Adaptor
Plug
9VDC.
Adaptor
(Figure3)
HEADSET CONNECTION
One of the special features of your phone is that your handset could utilize a headset
(not included) for hands-free communication. Insert the small plug at the end of your
headset cord to the headset jack at the side of the handset as shown in Figure 4. Follow
the procedures discussed in "Placing a Call" when to place and receive a call.
Note: The headset jack of your cordless telephone is compatible with 2.5mm headset plugs only. When
you plug in the headset into the headset jack, it automatically mutes the microphone and speaker
of the handset. Unplug the headset to return the handset to normal use.
Headset Jack
(Figure 4)
INITIAL SETUP
Please follow these steps before using the cordless telephone for the first time.
1. Ensure that the handset battery pack is installed and charged fully for at least 14 hours.
2. Ensure that all connections(line cord and adaptor cord) are properly inserted into rear of the base
unit.
SETTING THE TONE/PULSE MODE
Select the appropriate dialing service by moving the TONE/PULSE switch at the bottom of
unit:
TONE for Tone service , or
PULSE for Rotary service.
the base
SETTING THE HANDSET RINGER ON/OFF MODE
The handset must be set to ring ON mode in order to ring when receiving an incoming call. See Programs
Operation section on "RING ON/OFF SETTING".
TELEPHONE OPERATION
Place a Call
I. Pick up the handset and press the TALK button. The Call Timer starts to count. The base unit IN
USE LED indicator will light up.
9 030206A-1
