A SERVICE OF

logo

4. Hotkey Operation
21
Firmware Upgrade Mode
To set the CS-1762 / CS-1764 to Firmware Upgrade Mode, do the following:
1. Invoke HSM (see page 17 for details).
2. Key in: upgrade
3. Press [Enter].
The front panel LEDs flash to indicate Firmware Upgrade Mode is in
effect.
Note: To exit Firmware Upgrade Mode, you must power off the switch.
Restore Default Settings
To reset the CS-1762 / CS-1764 to its default hotkey settings, do the following:
1. Invoke HSM (see page 17 for details).
2. Press [R] [Enter].
All hotkey settings return to the factory default settings. See “Hotkey Default
Settings” on page 33.
cs1762.book Page 21 Friday, February 17, 2006 10:21 AM