Chapter 3. O peration
61200420L1-1 ESU 120e User Manual
3-9
To set up the ESU 120e to work with T-Watch PRO over the LAN,
follow these steps:
To set up the ESU 120e to work with T-Watch PRO over a direct
EIA-232 connection, the following steps are required:
Step Action
1 Set the Unit ID using the Front Panel. See Unit ID on
page page 6-4 for details.
2 Set TCP/IP interface to 10BaseT (or SLIP) using the
Front Panel.
3 Configure the IP address, default gateway, and subnet
mask using the Front Panel.
4 Follow the installation instructions for T-Watch PRO to
start the program and connect to the unit.
Step Action
1 Set the Unit ID and set a passcode using the Front Panel.
See Unit ID on page 6-4 and Set Passcode on page 6-2
for details.
2 Set the control port rate to the same setting as the PC
Com port.
3 Connect the PC Com port to the Chain-In port on the
ESU 120e using the DB25 adapter and modular cable
provided.
4 Follow the installation instructions for T-Watch PRO to
start the program and connect to the unit.
