14628 Central Blvd,
Chino, CA91710
tel:909.597.7588, fax:909.597.1939
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
PC 6415
15” Fanless Panel PC
Step 5: Lift the cover off and pull down the cover a bit to make it possible to lift the
cover further more after removing the retention screws. More strength is required to
separate the cover from the chassis.
5.5 Replacing Components
5.5.1 Memory Module Replacement
The flat panel PC is preinstalled with a 1 GB DDR2 memory module. If the memory
module fails, follow the instructions below to replace it.
Step 1: Remove the aluminum back cover. See Section 5.4.1 above.
Step 2: Locate the DDR2 SO-DIMM on the motherboard (Figure 5-2).
Step 3: Remove the DDR memory module by pulling both the spring retainer clips
outward from the socket.
Step 4: Grasp the DDR memory module by the edges and carefully pull it out of the
socket.
Step 5: Install the new DDR memory module by pushing it into the socket at an angle.
Step 6: Gently pull the spring retainer clips of the SO-DIMM socket out and push the
rear of the DDR memory module down (Figure 5-3).
Step 7: Release the spring retainer clips on the SO-DIMM socket. They clip into place
and secure the DDR memory module in the socket.
