3 - 4 ONline Ethernet 10BASE-FL Installation and Operation Guide
Setting the Dip Switches
The 10BASE-FL Module has two 8-position dip switches (SW1 and SW2)
located on the rear of the board. Figure 3-1 shows the location and default
settings of the SW1 and SW2 dip switches. You may need to reconfigure
one or more of these switches depending on your configuration
requirements.
The dip switch settings for the 10BASE-FL Module are ignored if an
appropriate ONline management module is installed in the concentrator.
For this reason, use the management commands (rather than the dip
switches) to configure the 10BASE-FL Module. If you have an installed
Ethernet Management Module (EMM) at Version 4.01 or higher, install the
module first and then refer to the Configuring the Module section in this
chapter for more information.
The remainder of this section describes:
❑ Setting Dip Switch SW1
❑ Setting Dip Switch SW2
6. If you have a management module
installed in the concentrator, configure
the module using the management
commands.
Configuring the
Module
7. Verify LED status for normal operation. Verifying LED and
Network Assignments
Table 3-1. Quick Installation Procedures (Continued)
Step Procedure Section Title
