Filter
Top Products
–6–
EAS00739
2. Battery
SCheck the condition of the battery.
Refer to “CHECKING AND CHARGING
THE BATTERY” in chapter 3. (Manual No.:
5PS1-AE1)
YES NO
SClean the battery
terminals.
SRecharge or re-
place the battery.
Minimum open-circuit voltage
12.8 V or more at 20_C
SIs the battery OK?
YES
NO
3. Starter motor
SConnect the positive battery terminal and
starter motor lead with a jumper lead .
Repair or replace the
starter motor.
SA wire that is used as a jumper lead
must have at least the same capacity or
more as that of the battery lead, other-
wise the jumper lead may burn.
SThis check is likely to produce sparks,
therefore make sure nothing flammable
is in the vicinity.
SDoes the starter motor turn?
WARNING
1
2 3
EAS00758
ELECTRIC STARTING SYSTEM
ELEC
The starter motor fails to turn.
NOTE:
YES
NO
1. Main and ignition fuses
SCheck the main and ignition fuses for conti-
nuity.
Refer to “CHECKING THE FUSES” in chap-
ter 3. (Manual No.: 5PS1-AE1)
SAre the main and ignition fuses OK?
Replace the fuse(s).
EAS00738
EAS00757
TROUBLESHOOTING
Check:
1. main and ignition fuses
2. battery
3. starter motor
4. starting circuit cut-off relay
5. diode
6. starter relay
7. main switch
8. engine stop switch
9. neutral switch
10. sidestand switch
11. clutch switch
12. start switch
13. wiring connections
(of the entire starting system)
SBefore troubleshooting, remove the following
part(s):
1. seat
2. fuel tank
3. air filter case
4. side cowlings
STroubleshoot with the following special
tool(s).
Pocket tester
90890-03132