Filter
Top Products
Recording Your Performance
P-115 Owner’s Manual
21
To record the right part ([R]):
To record the left part ([L]):
After a while, the [REC] lamp will flash at the
current tempo. If necessary, set the tempo (page
18).
If data has already been recorded to the other
Part:
The data in this Part will be played back while
recording. To turn the Part off or on, hold down
[PLAY] and press the appropriate Part button.
3
Start recording.
Play the keyboard or press [PLAY] to start record-
ing. The [REC] lamp lights up while the [PLAY]
lamp flashes at the current tempo.
4
Press either [REC] or [PLAY] to stop
recording.
The [REC] and [PLAY] lamps flash, indicating
that the recorded data is being stored. After the
operation is completed, the [REC] lamp will be
turned off.
5
If desired, record the other part by
repeating Steps 1 – 4.
6
To hear the recorded Song, Press
[PLAY] to start playback.
Press [PLAY] again to stop playback.
1
Press [REC] to engage Record Ready
mode.
The [REC] lamp will flash.
2
While holding down [PLAY], press [REC]
so that both the lamps flash.
3
Press any one of the buttons [PLAY],
[REC], [L] or [R] to delete the data of the
entire Song.
After the operation is completed, both lamps turn
off.
To delete a specific Part:
1
While holding down [REC], press [L] or
[R] to engage the Record Ready mode.
The [REC] lamp will flash.
2
Press [PLAY] to start recording without
playing the keyboard.
3
Press [REC] or [PLAY] to stop recording.
All data recorded for the selected Part will be
deleted, and the lamp turns off.
The following parameter settings of the Song can be
changed after the Record operation is completed.
For individual parts:
Voice, Balance, Reverb Depth, Pedal (Damper/
Soft)
For the entire Song:
Tempo, Reverb Type, Pianist Style Volume
1
Make the settings of the above
parameters.
Continue to the next page.
•You can use the Metronome/Rhythm while recording; however, the Met-
ronome/Rhythm sound will not be recorded.
• Never turn off the power while the recorded data is
being stored (while the lamps are flashing). Other-
wise, all recorded data will be lost.
NOTE
NOTICE
Deleting the User Song
•To exit from this status, press any other button such as [DEMO/SONG].
Changing the Initial Settings of the
Recorded Song
NOTE