Filter
Top Products
6
C
omplete the assembly of your Dumbo Pylon by attaching the Dumbo figure and support
rods to the structure. Figure 2 illustrates the following procedure.
1. Note that the supporting rod has different shaped ends. Insert the flattened end of the
support rods into the tube protruding from the top of the pylon. Refer to the diagram for
further assistance.
2. Insert the D-shaped ends of the wires into the openings in the bottom of the Dumbo figure.
Attaching the figure to your Dumbo Pylon
Figure 2. Installing the support rods
Support rod (bottom)
Support rod (top)
Mounting hole on
top of pylon
Mounting hole, bottom
of Dumbo
A
djust the voltage to the accessory to control the speed at which Dumbo circles the tower.
Increasing the voltage will cause Dumbo to circle faster; decreasing the voltage will cause
Dumbo to travel slower. To turn the accessory off, turn off the power supply or use the switch
attached to the wires in Step 1 on page 3.
Operating your Dumbo Pylon with a conventional power supply